Are you finding trouble in programming your DISH Network remote? If yes then don’t worry because here is few steps which you need to follow and all your task will be done smoothly. So the multi tasking remote which can be used to control TV set and also DVD player can be programmed by following the steps mentioned below-
- Turn on your TV by pressing the power button
- Now point the remote at your TV.
- Hold the TV button on the remote and release it when you see the mode buttons light on.
- Now you need to enter the three digit code which you can find on the manual or the DISH Network site which will be listed by brands.
- Press ok or the # button once you are done with the codes and then you will see the mode button flashes 3 times.
- Now the device which was programmed turns off as you press the power button.
- Turn on the device again by pressing the power button and if you find the remote is not working then repeat the steps again.